|
|
Post by Mr.Scott on Apr 23, 2016 18:23:45 GMT -5
Attach a 20k ohm Trimmer to one of the points shown either point can be used lower resistance to raise voltage. The resistance value of the point is just over 500ohm and being my first try I used a 20k trimmer (for safety) you could probably use a 10k but I got a bump from 1.5v to 1.53v with the 20k so I would stick with the 20k.  |
|
|
|
Post by blaylock on Aug 9, 2016 13:40:18 GMT -5
I used the 10k trimm and got good results too. Here is a link to my mod. All credit goes to Macsbeach. I found his guide on the "older" forum and followed it with exception of the 10k pot. (20k wasn't available at the time). So far I've noticed a bump from +0.064v to +0.25v. There's more in it but chickened out at 1.80v on dice with my 6000+  |
|
|
|
Post by Macsbeach98 on Aug 9, 2016 17:15:28 GMT -5
I am sure that I have seen this mod before  I will have to look at it again one day and work out how to raise the IMC voltage thats where the action is at. |
|
|
|
Post by Mr.Scott on Aug 9, 2016 17:16:49 GMT -5
I used a 10k also, only because I didn't have a 20k left. Works fine. |
|
|
|
Post by alpi on Mar 31, 2017 17:32:03 GMT -5
Did that mod on my UD3P. Works fine ! Thanks for sharing it, it's very useful and easy mod for these boards !  |
|
