|
Post by Mr.Scott on May 14, 2016 7:26:41 GMT -5
VDD mod The chipset voltage is measured from the mosfet leg shown. Default voltage is around 1.55v. Located near the Southbridge is the RT9214 chip. You can solder a 1K ohms variable resistor to the spot marked and ground the other end of the resistor. Set VR at maximum resistance. This will increase chipset voltage to 1.7v. Tune down VR to increase voltage. Take note that the chipset does get quite hot so be sure to give it good cooling. Vcore mod Solder a wire to each of the 4 solder pads circled. Connect all 4 wires to ground to force maximum voltage.
|
|
|
Post by mistone on Feb 10, 2019 14:40:55 GMT -5
how about a8n-sli-premium? i found regular a8n-sli are pretty cheap. there is also a8n-sli-SE. asus as always has to make 5 boards with same name at least lol
|
|