Asus PC-DL Deluxe Rev. 1.05 Volt mods

[dr4g00n]

Pretty straightforward mods, nothing too complicated and they work well, currently running 1.61V VCore & 2.92V VDimm after the mods.

There is also the NB volt mod which I might add later if I end up needing it.

VCore mod, ADP3180: 20K VR from Pin 8 (Feedback) to GND.





VDimm mod, RT9202: 20K VR from Pin 6 (Feedback) to GND.

[mrpaco]

That I can use. Cool...

[dr4g00n]

Just as a heads up, OVP kicks in just past 1.6V, have to do another mod to get it higher. I will post it later once I figure it out.



And here is the "Moose mod" for booting @ 200-233FSB credited to Mooseifert on 2cpu.com. (Can't get this to work on mine with dual 2.4GHz M0 Prestonia's. Probably just the cpu's themselves as only one can do 192FSB stable via SetFSB).

Here are the instructions on how to get going, remember that you must not break off any pins:

boot at 133mhz with jumpers on 2-4 and 1-3 (using the labels in the manual)

here are they like you see them on the motherboard:

2-1
4-3
6-5

set multi to the highest you cpu will do at 200mhz/233Mhz (in my case that's 18/15 respectively)

set memory speed to anything you want (i suggest auto)

set SPD to auto

Save and exit and turn the computer off

set only one jumper to 3-5

now you start the computer and there you go. 200mhz fsb

[mrpaco]

I will have to try that out when I pull that board out.
thanx

[dr4g00n]

No problem. 

Did a little test of how well it worked.

VDimm mod helps a lot for high FSB freq. Had it as high as 227.5MHz.
VCore: 1.61V, VDimm: 2.85V 

[mrpaco]

Very nice...

[funsoul]

Thanks! Don't have this board anymore so nothing to add but thanks for bringing me back in time a bit (2004?!?).