Testing Single stick Corsair 3000mhz LED Hynix module.

[ShrimpBrime]

So I pulled a stick for testing. 

It boots alone by itself at DOCP rating, Gear Down mode enabled default pushes cas to 16.
Had to make timing adjustments, but works fine at it's rated XMP.

This Memory stick will not post 3200mhz at even 1.410v and SOC voltage raised to 1.08v

Budget memory at it's finest.

Test system B450-I gaming ROG and 2700x processor at stock.

[ShrimpBrime]

So with some further testing, pushed 3133mhz CL 16-17-17 @ 1.410v.

A couple of screen shots here at this point, nothing fancy, but doing better than the comparison 2700x on the list. Not bad. Beating out CL16-20-20 isn't really that impressive here.

Going to push voltage harder at 3200mhz, see if I can get a post. So far 2 tries CL 16-16-16 and CL 16-17-17 1.410v and no post. Outcome doesn't look good.

After that, will lower frequency back to 3000 DOCP and try out some tighter timing sets, see where it ends up. Will not exceed 1.610v with this memory, I don't think it'll help except to fry it.

[ShrimpBrime]

Back at it and running 3200mhz @ 1.510v. CL 16-17-17.
After Here I'm going to try 16-16-16 @ 3200mhz straight across see if it posts and if it does better performance wise.

[ShrimpBrime]

Had to go looser. 

16-18-18 1.60-v (probably could use less) 
Going for golds over here. 

3266mhz! Gaining some speed and lowering latency... little by little.

[ShrimpBrime]

More and more we go.

3333mhz tested with Quick Memory test OK with 0 errors.

CL 16-18-18 @ 1.610v - Going for max, never mind the votlage usage lol.

[ShrimpBrime]

Ahem. Test 3400mhz 16-18-18 1.610v

Corsair starting to show promises.

[ShrimpBrime]

3466mhz, threw in Cinebench. Cpu is still stock, OC memory only.

Still CL16-18-18 @ 1.610v - I think it likes it

For those wondering, the Loop in the memory test ok is 2 seconds long. It loads 95% back down to system usage. You can however pause this and keep the memory at a constant load, but won't show errors, not that I've seen any yet.....

[ShrimpBrime]

Now 3533mhz CL16-18-18 1T 1.610v Corsair 3000 sticks. A-Die.  (I do not have selection for straight 3500mhz)

Memory is not stable upon testing. Cinebench halted and Memory test OK blue screen of death ( try to avoid these aye aye,captain )

Getting crafty for more speed, I may try jumping into  Cas 18-20-20 / Cas 18-18-18 and see if I can keep the 1T command rate. Alternative, more voltage. Or maybe both?

Dunno, here's unstable of any testing 3533mhz.